DuraLabel 9000 - Page 17

DuraLabel.com | 800.788.5572 3.2 Using a USB Cable | 15
CONNECTING THE PRINTER
D. Select DuraLabel 9000 and click Next on
the DuraLabel Driver Selection window that
appears.
E. Choose the install location and click Install
on the Choose Install Location window
that appears. An Installing window shows
installation progress.
F. Select Install printer drivers
*
on the Driver
Wizard window that appears and click Next.
*
NOTE: You will receive a notice if a previous driver
is found that should be removed. Please refer to
Section 3.4, Upgrading a Driver, for instructions
on uninstalling a driver.
G. A Plug and Play Detection window appears.
Highlight Graphic Products DuraLabel 9000
and click Next.
H. Enter printer name in the Printer name field in
the Specify Printer Name window that opens;
set it as the default printer by checking the box
below the Printer name field. Choose a sharing
option, then click Next.
I. Review information on the Completing the
Seagull Driver Wizard window that appears.
Click Finish if the information is correct. If
it isn’t, correct previous selections and click
Finish when the information is correct.
Selecting a DuraLabel Driver
Driver Install Location Window
Installing Window
Install Printer Driver Window
Install Driver for a Plug and Play Printer. Specify Printer Name and Default and
Sharing Status.
Completing the Seagull Driver Wizard