DuraLabel.com | 800.788.5572
4.2 Die-Cut Label Printing Instructions | 21
CONFIGURING PRINTER DRIVERS
These settings may be adjusted in Printer Properties* when printing your labels.
*NOTE: This will show as Preferences if accessing File > Print from DuraSuite
Labeling Software.
Printing Preferences dialog box,
with Type set to “Continuous” and
Occurrence set to “After Every Page” on
the Stock tab
Set the Printing Preferences
Occurrence menu to “After Job” to
print multiple labels on a single length
of supply.
4.2 Die-Cut Label Printing Instructions
4.2.1 LABEL SUPPLY CALIBRATION
Label supply must be calibrated to print die-cut labels. Using the menu on the left side
of the front of your printer, follow these steps:
A. Press the Menu button.
B. Select Setup.
C. Select Sensor.
D. Select Calibration.
E. Select Gap Mode.
F. Select Automatic.
G. The printer will begin to feed supply as it calibrates.
H. Follow directions in Section 4.2.2, Driver Settings.
To Next Page
Loading...
