DuraLabel.com | 800.788.5572
9.3 Platen Roller | 43
CLEANING AND GENERAL MAINTENANCE
9.3 Platen Roller
A. Place a cleaning swab between
your forefinger and thumb and
squeeze until it snaps. Alcohol will
be distributed to the cotton side of
the swab.
B. Run the swab back and forth across
the platen roller several times to
remove any buildup. Rotate the
platen roller to clean all sides of the
roller.
C. Give the platen roller a couple minutes to dry, then reload your ribbon and supply.
Your DuraLabel 9000 is now cleaned and ready to use.
NOTE: To maintain optimal performance, the DuraLabel 9000 printer should be
cleaned after every two rolls of supply. The print head, cutter mechanism and platen
roller should be cleaned with alcohol swabs to remove buildup of adhesive, dust
and other substances. Always turn the printer OFF before cleaning, performing
maintenance or loading supplies.
Cleaning Platen Roller
To Next Page
Loading...
