26 | 4.6 Adjusting Darkness
DuraLabel.com | 800.788.5572
CONFIGURING PRINTER DRIVERS
4.6 Adjusting Darkness
Change darkness settings from the Options tab, dragging the slider on the Darkness
bar (see Figure 14). Darkness can be adjusted in single increments from 0 – 15. Keep
the Graphics Format settings on Automatic.
Recommended Darkness Settings for Ribbon: (Print Speed Set at 2)
Ribbon
Standard
Black
White Red Blue Green Orange
Die-Cut
Labels
Darkness 5-8 5-8 5-8 5-8 5-8 5-8 9-12
When satisfied with all your settings, click Apply, then OK. Your driver is now set up and
ready to create labels.
NOTE: You may need to change print settings to optimize the DuraLabel 9000 for
printing with some ribbons and specialty supply. Higher speeds generally require
higher darkness. If a ribbon wrinkles, lower the darkness. Increase darkness to ensure
all ink is being transferred from the ink ribbon.
To Next Page
Loading...
