DuraLabel 9000 - Configuring Printer Drivers; Continuous Vinyl Printing Setup

20 | 4.1 Continuous Vinyl Printing Instructions DuraLabel.com | 800.788.5572
 &RQÀJXULQJ3ULQWHU'ULYHUV
IMPORTANT! Perform the driver conÀguration before opening the document you plan
to print or close any documents you currently have open before making these changes.
A. Click Start > Devices and Printers*. A Devices, Printers and Faxes window
appears.
*NOTE: If you do not Ànd Devices and Printers in your Start menu, you can access
it in your Control Panel.
B. Right-click the Graphic Products DuraLabel 9000 icon and select Printing
preferences. A Printing Preferences dialog box appears.
C. Click the Page Setup tab and select Landscape or
Portrait, depending on your label’s orientation.
D. If your label size is not shown in the Stock Name
drop-down menu, click Edit and set the size to match
your label size.
NOTE: Your DuraLabel 9000 printer drivers are preset
to several print values. Please be aware that changing
a preset value is not fully supported by all software
programs. For best results, make changes to preset
values from the Devices and Printers window.
4.1 Continuous Vinyl Printing Instructions
Your printer driver has been preset to common settings to reduce the steps needed to
set them manually. You can change your settings by following these steps:
A. Select the Stock tab, then select Continuous from the Type drop-down menu under
“Media Settings.”
B. To cut after each label, select Cut from the Post-Print Action drop-down menu and
select After Every Page from the Occurrence drop-down menu.
C. To cut after each job, select Cut from the Post-Print Action drop-down menu and
select After Job from the Occurrence drop-down menu.
D. Click Apply.
Printing Preferences dialog box with
Page Setup tab selected