Dynamica HALO DB-20 - Page 49

Press <3> to select Curve Setup from the photometry submenu, a submenu list
appears on the right side of the screen as shown in the illustration below:
11/11/02 11:35 600.0 nm 0.854 ABS
Photometry
1 Parameter Setup 1 1st order
2 Sample Setup 2 STD NUM
3 Curve Setup 3 Curve Data 10
4 Print Setup 4 Repeat NUM 1
5 System Setup 5 HI Limit 9999
6 Save Parameter 6 LO Limit 0
7 Forward
Select Function: _
Curve Type
Note: Function 2 to function 6 can only work at the “Conc”
data mode.
Curve Type: Press <1> on the keyboard. The following four types of curves
selectable are shown in the illustration below.
11/11/02 11:35 600.0 nm 0.854 ABS
Photometry
1 Parameter Setup 1 1st order
2 Sample Setup 2 STD NUM
3 Curve Setup 3 Curve Data 10
4 Print Setup 4 Repeat NUM 1
5 System Setup 5 HI Limit 9999
6 Save Parameter 6 LO Limit 0
7 Forward
Select Function: _
Curve Type
1 1st order 2 2nd order 3 Segement 4 K-factor
3-8