Dynon SkyView Classic - Engine Alerts and Parameters

Messages and Alerts
SkyView Classic Pilot’s User Guide – Revision Z 12-6
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Engine Monitor”
“Oil Pressure”
“Fuel Pressure”
“Fuel Flow”
“Fuel Quantity”
“Electrical Current”
“Voltage”
“Exhaust Gas Temperature”
“Cylinder Head Temperature”
“Engine Speed”
<Engine Parameter>
HIGH or LOW
Engine Parameter High or Low.
“High” or “Low” is not displayed for
all parameters.
Engine Alerts can be optionally
configured to be inhibited before
engine start or 5 minutes, whichever
comes first. See the SkyView Classic /
SE / HDX System Installation Guide
for details.
“Warning”
ADAHRS CAL
CORRUPT
Contact Dynon Avionics for
assistance
“Warning”
DEMO MODE
System is in Dynon demo mode and
is not airworthy
“Warning”
ARINC-429 OFFLINE
The SV-ARINC-429 module is not
communicating with SkyView.
“Warning”
BACKUP BATTERY
LOW
The backup battery connected to this
display is low.
“Warning”
SKYNET POWER
FAULT
A fault has been detected in the
wires that provide power to SkyView
Network devices.
“Warning”
AUDIO SUBSYSTEM
FAIL
SkyView has detected a problem with
the audio system.
“Check Canopy Latch”
CHECK CANOPY
LATCH
A canopy latch alert is configured;
The canopy is not latched; and the
engine has been advanced past a
configured RPM.
“Warning”
MAG FACT CAL
CORRUPT
Contact Dynon Avionics for
assistance
“Caution”
STANDBY NETWORK
ERROR
SkyView Network has lost its
secondary standby network
redundancy. See below for more
information.
“Caution”
POSITION SOURCE or
GPS X FAIL
Position source (GPS) failure
“Caution”
XPNDR HEX CODE
NOT SET
A SkyView Transponder or ADS-B
receiver is installed but the HEX Code
has not been set.