Dynon SkyView Classic - Page 244

Messages and Alerts
SkyView Classic Pilot’s User Guide – Revision Z 12-7
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Caution”
EMS SFG FILE
MISMATCH
The Engine sensor indications may be
incorrect, and screens may disagree.
“Caution”
NO ADSB OUT: GPS
LOST
The GPS source that provides GPS
position to the SV-XPNDR-261 for
ADS-B Out use is offline.
“Caution”
BACKUP BATTERY IN
USE
System has switched to SkyView
Backup Battery.
“Caution”
OTHER DISPLAY
OFFLINE
A SkyView Display has failed or is no
longer communicating via SkyView
Network.
“Caution”
NEED COMPASS CAL
Magnetic compass heading in either
the SV-ADAHRS-20X or SV-MAG-236
is not calibrated.
“Caution”
COMPASS FAIL
The SkyView Remote Magnetometer
has failed or is no longer
communicating via SkyView Network.
“Caution”
NEED USER AOA CAL
AOA is not properly calibrated
“Caution”
CHECK PITOT HEAT
Airspeed information is not available;
GPS is being used to aid in the
computation of attitude information;
Attitude may be degraded
“Caution”
ADAHRS CAL OLD
Contact Dynon Avionics for
assistance
“Caution”
AP BROKEN
DISCONNECT
Autopilot disconnect switch wire is
broken
“Caution”
AP DISCONNECT
STUCK
Autopilot disconnect switch wire is
stuck
“Caution”
XPNDR ALT ENCODER
FAIL
Altitude is not being sent to the SV-
XPNDR-261/262 because it is not
available from its nominal barometric
altitude source.
“Caution”
ACTV ADAHRS
VIBRATION
The currently-active ADAHRS has
detected vibration that will affect G
Meter and Autopilot, attitude
indicator performance. Troubleshoot
when able.
“Caution”
ADS-B IN OFFLINE
The connected ADS-B traffic/weather
receiver has failed or is no longer
communicating with SkyView.