Dynon SkyView Classic - Page 248

Messages and Alerts
SkyView Classic Pilot’s User Guide – Revision Z 12-11
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Go Around”
None
n/a
The autopilot go around function has
been engaged.
“Trim Nose Up”
None
n/a
The autopilot requires nose up trim
to maintain control of the aircraft,
and has been annunciating this
visually on the display for at least 30
seconds. This alert is played a
maximum of once every 30 seconds.
“Trim Nose Down”
None
n/a
The autopilot requires nose down
trim to maintain control of the
aircraft, and has been annunciating
this visually on the display for at least
30 seconds. This alert is played a
maximum of once every 30 seconds.
“Autopilot Airspeed
High/Low”
None
n/a
The autopilot airspeed limits are
exceeded.
“Approaching Minimums”
None
n/a
Altitude is within 200 feet of the MIN
bug
“Minimums”
None
n/a
Aircraft has descended below MIN
bug
“Approaching Altitude” /
“Leaving Altitude”
None
n/a
Altitude alerter notification that the
aircraft is approaching or leaving the
bugged altitude
“Overspeed”
None
n/a
Indicated airspeed is exceeding Vne
“Flaps Overspeed”
None
n/a
Indicated airspeed is exceeding Vfe
(and flaps are at least partially
deployed)
“Flight Plan Updated”
None
n/a
A new flight plan has been received
by SkyView from an external flight
plan source (such as ForeFlight)
“Approaching Waypoint”
None
n/a
The aircraft is within 30 seconds of
an upcoming SkyView flight plan
waypoint (except the final waypoint)
“Check Gear”
None
n/a
The aircraft is configured as a
Retractable gear, and the Landing
Gear is UP, and the aircraft is
descending through the configured
minimum warning speed.