Dynon SkyView Classic - Page 247

Messages and Alerts
SkyView Classic Pilot’s User Guide – Revision Z 12-10
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Message”
CPU TEMP HIGH
The display internal temperature is
significantly higher than the normal
operating temperature.
“Message”
BACKUP BATT LOW
CHARGE
The backup battery connected to this
display is not charged.
“Message”
Wi-Fi Offline
The Wi-Fi Adapter is currently offline.
“Message”
SYSTEM EVENT n
SkyView has detected a possible
problem with software or hardware.
Please fill out form at
http://dynon.aero/event5 when
convenient.
“Message”
XPNDR WARNING
MESSAGE
The transponder has detected a
problem and notified SkyView. See
the SETUP MENU for the specific
problem.
“Gees” (repeats)
None
n/a
The G meter is in the yellow caution
range
“Over Gees” (repeats)
None
n/a
The G meter is in the red warning
range
“Traffic Not Available”
None
n/a
Traffic is not available from a
previously available source
“Traffic”
None
n/a
A new traffic advisory target has
been identified. Note that this audio
alert is suppressed when not in flight
to reduce nuisance alerts. Other
visual traffic alert indications persist,
however.
“Autopilot”
None
n/a
The roll or pitch autopilot axis has
been engaged
“Autopilot Mode”
None
n/a
The autopilot roll mode has changed
since it was engaged. This includes
sequencing onto an armed mode
(such as an ALT Hold > VNAV
sequence)
“Autopilot Disconnect”
None
n/a
The roll and pitch autopilot axis has
disconnected
“Autopilot Roll Disconnect”
None
n/a
Only the roll autopilot axis has
disconnected
“Autopilot Pitch Disconnect”
None
n/a
Only the pitch autopilot axis has
disconnected