Dynon SkyView Classic - Page 246

Messages and Alerts
SkyView Classic Pilot’s User Guide – Revision Z 12-9
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Switch Fuel Tank”
SWITCH FUEL TANK
The optionally-configured fuel tank
timer has reached its pre-configured
time or fuel quantity consumption
limit.
“Timer Expired”
TIMER EXPIRED
A DOWN timer under TOOLS > TIMER
has expired.
“Message”
ROLL SERVO OFFLINE
The Roll Autopilot servo has stopped
communicating with SkyView. Will be
seen if Autopilot servos are not
receiving power.
“Message”
PITCH SERVO OFFLINE
The Pitch Autopilot servo has
stopped communicating with
SkyView. Will be seen if Autopilot
servos are not receiving power.
“Message”
TRANSPONDER FAIL
Transponder failure.
“Message”
EXT LEVEL BUTTON
STUCK
The external Level Button is stuck
and is inoperative.
“Message”
CHECK BARO SETTING
The current BARO setting and the
nearest METAR-based altimeter
setting are more than .1 inHg apart.
Or the aircraft has descended below
FL180 and the BARO should be reset.
“Message”
BATTERY TEST FAILED
A full backup battery test was
performed, and it failed. See the
Installation Guide for further
troubleshooting information.
“Message”
BATTERY TEST
NEEDED
A year or more has passed since the
last successful backup battery test, or
the last three SkyView shutdowns
were abnormal.
“Message”
SOFTWARE
MISMATCH
SkyView components are not all
running the same firmware version
“Message”
OEM CONFIG
MISMATCH
OEM-customized displays are not in
sync with each other
“Message”
TAIL # MISMATCH
Tail numbers differ between SkyView
displays – settings will not properly
synchronize
“Message”
XPNDR NOT IN ALT
MODE
The aircraft is in flight and the
Transponder is not in Alt Mode