E4D Technologies Nevo - Bridge Setup and Material Recommendations; Updated Block Recommendation Chart; Bridge Setup Tab Procedures

40 pages

To Next Page

To Previous Page

Customer Support 800.537.6070 27

Updated Block Recommendation Chart (Subject to Release Dates)

• IPS e.max 16 mm block for longer anteriors and 32 mm anterior bridge

• Telio CAD blocks are intended for long-term provisional restorations (maximum wear of 12months)

(40and55 mm)

• Zirlux FC2 is full contour zirconia that can be milled with the E4D Milling Center. Zirlux requires a

sintering oven. Individual restoration (20 mm) and bridge block (55 mm).

Bridge Setup Tab

A bridge is made up of two or more restorations that are connected. On the Setup tab, select each tooth on

the anatomical model that is part of the bridge. For each tooth, you must select the restoration type.

1. Select each tooth that is part of the bridge - the abutment(s) and the pontic(s).

2. Click Link. The cursor changes to a chain symbol.

3. Click the mesial and distal teeth of the bridge. After each end of the bridge is selected, the teeth turn

purple.