E4D Technologies Nevo - Time Saver Tools: Bite Registration; Using Time Saver for Bite Registration

22 E4D NEVO Version 5.0 10822801.C
The Align Pre-op icon displays a green light if the models are aligned. A red light means that alignment must
be done manually.
12. Click the Align Pre-op button to verify the alignment. See below for how to manually align the models
if needed. Click the button again to deactivate it and return to the main scan screen.
Time Saver: Bite Registration
1. On the Setup tab, select Bite Registration.
2. On the Scan tab, click Scan Prep and scan the preparation model  rst.
3. Click Scan Bite.
A Time Saver message appears. This message appears when the preparation is scanned  rst. The Time Saver
option allows you to duplicate the preparation model and use the same data for the bite registration model.
4. Click OK to use the Time Saver. If you do not wish to use the Time Saver option, the bite registration and
proximals can be scanned on their own. The following instructions assume the use of the Time Saver option.
A copy of the preparation model is created in the bite registration model color.
5. Click the Eraser Tool.