Remove the
aligning tool.
Remove four yellow
shipping bolts in a
crisscross pattern.
Pin
10
9
Use a six once hammer and
a 1/4" flat nose punch to
lightly tap the four separator
plate pins toward the flywheel.
Only part of the pin should be visible.
If installing Solo Advantage Clutch,
proceed to Step 12.
11
14
12
Install brass fitting into grease
port on left side of release bearing
housing using Weatherhead socket.
Tighten hand tight and continue to
turn until the opening of the fitting
is facing toward the 6 o’clock position.
13
Install lube hose into
brass fitting and tighten
until hand tight,then turn an
additional 2 turns.
Lubricate release bearing until
grease purges from release bearing
housing. Use NLGI grade 2 or 3 Lithium
complex grease. Reference Eaton
lubrication manu
al TCMT0021
for specific instructions.
Note: The example shown is of a Lube Hose Attachment
for a heavy-duty Hydraulic release system.
Note: A-8173 hand hole cover with
grommet is required with HD Solo
Advantage clutch used with hydraulic
release system.
To Next Page
Loading...
