1
Determine if the release bearing travel is
correct. Measure the distance between the
clutch brake and the release bearing with
the clutch pedal up. If the measurement is
between 0.490" and 0.590", the Solo has
set itself correctly.
Note: Yoke gap only applies to mechanical
linkage. Most hydraulic linkages operate
without yoke gap.
Tool Part Code:
RR1005CL
K-Line 1-800-824-5546
2
If the release bearing travel is less than 0.490"
the Solo must be reset. A common cause of this
is the transmission was pulled in with the release
arm during clutch installation.
3
Rotate the engine so that the cam tab can
be reached through the transmission
inspection opening.
4
Push the clutch pedal to the floor. While the clutch pedal
is pushed to the floor have someone push the cam tab to
the new position using finger pressure or the Solo tool.
Once the cam tab is pushed to the new position you can
release the clutch pedal.
Note: If the cam tab does not move, there is not enough
release bearing travel to allow the cams to separate. In
this case, loosen the transmission and install 1/2"
spacers between the flywheel housing and bell housing.
With the spacers in place push the clutch pedal to the
floor while someone pushes the cam tab to the new
position. Once the tab is in the new position release the
clutch pedal and remove the spacers. Torque the
tra
nsmission mounting bolts.
Release
Bearing
Clutch
Brake
Measure the release
bearing travel
REPLACE
To Next Page
Loading...
