49
Hydraulic Linkage
Hydraulic Linkage
Verify Linkage System Stroke
Measure the release bearing position with the pedal up and
pedal down to verify bearing travel.
The hydraulic linkage should allow for a minimum of 0.600" of
yoke finger movement: 0.500"-0.560" for clutch release plus
additional movement for clutch brake squeeze.
If the system does not provide enough movement of the
release bearing, the clutch will not adjust and the bearing will
move away from the transmission and lose clutch brake
squeeze.
If the system is operational, clutch replacement may be nec-
essary. If replacing the clutch, you must adhere to OEM war-
ranty guidelines prior to claim disposition.
Master Cylinder Installation
Master Cylinder
Master cylinder may be mounted at any angle ranging from
vertical to horizontal, depending on application.
Remote Reservoir
Constant rise in hose from master cylinder to reservoir.
1 - Master cylinder
2 - Reservoir
3 - Pushrod
4 - Bolts (2), M8 x 1.25 mm (torque 20-25 N•m)
5 - To booster or slave
To Next Page
Loading...
