Slide the wear indicator tab to
the “GOOD” position and hold
it in place with a magnet
4
Install 4 shipping bolts (7/16" x 14 x
1-3/4" UNC, hex head). Progressively
tighten (no air wrenches) the 4
shipping bolts (crisscross pattern)
until the face of the pressure plate is
1.75"-1.78" (44.4-45.2 mm) below
the mounting surface.
5
Remove the 4 shipping
bolts if they have been
installed.
1
Center the ram and
press downward on the
retainer until it comes to
a stop. Lock the ram in
position.
3
Reinstall the clutch using
the original installation
instructions.
6
Support the clutch in an arbor press
with the bearing facing down.
Shipping Bolts
Note: Make sure there is at
least 1" of space to allow
the bearing to move
down and to provide
access to the
shipping bolts.
Note: This important step will reset the
pressure plate separator pins and allow
the clutch to release after
reinstallation.
2
1.75"-1.78"
(44.4-45.2 mm)
To Next Page
Loading...
