2
Solo Advantage
Self-Adjusting Clutches
Install Solo Advantage Heavy-Duty 15.5" Clutch
Measure Engine Flywheel Housing and Flywheel
Engine flywheel housing and flywheel must meet these specifications or it may result in premature clutch failure. Remove and
replace old pilot bearing per engine manufacturer instructions. All gauge contact surfaces must be clean and dry. Clean flywheel
surfaces of all grease, oil, and rust preventatives. Failure to perform this function can affect the performance of the clutch.
Use a dial indicator and check the following:
Pilot Bearing Bore Runout
Flywheel Housing Face Runout
Secure dial
indicator base
to flywheel
housing face.
Rotate flywheel
one revolution.
Maximum runout is
0.008" (0.20 mm).
1
Position gauge finger
so that it contacts
pilot bearing bore.
2
Rotate flywheel one
revolution. Maximum
runout is 0.005" (0.13 mm).
3
Secure dial indicator
base to flywheel near
the outer edge.
1
Put gauge finger in
contact with face of
flywheel housing.
2
3
Flywheel Face Runout
Flywheel Housing I.D. Runout
Secure dial indicator
base to crankshaft.
1
Put gauge finger
against flywheel
housing pilot I.D.
2
Rotate flywheel one
revolution. Maximum
runout is 0.008" (0.20 mm).
3
Rotate flywheel one
revolution. Maximum
runout is 0.008" (0.20 mm).
3
Put gauge finger in
contact with flywheel
face near the outer edge.
2
Secure dial indicator
base to flywheel
housing face.
1
To Next Page
Loading...
