Eaton CLSM0200 - ECA Clutch Adjustment

40
ECA Clutch
ECA Clutch Adjustment
This command signals the ECA to actuate the clutch in order to set the adjustment after an ECA Clutch has been reset or
replaced. Fault code 26 or 27 indicate that the clutch may have come out of adjustment. Refer to Troubleshooting Guide
TRTS0930 for more fault code detail. A clutch adjustment should always be performed after a clutch replacement.
Open and expand the Advanced
Product Functions tree.
4
5
6
Click on ECA
Clutch Service.
Click on transmission.
Note: Advanced Product
Functions appear.
2
Turn ignition
switch to on.
1
F
FO
NO
TRATS
2
Plug 9-pin connector
into dash port.
3
Click on ServiceRanger
icon to launch program.
3