Have assistant hold
clutch pedal down.
While pedal is held down,
move wear tab to the left
(GOOD) position.
Note: If the cam does not
move, loosen transmission and
install 1/2" spacers between the
clutch housing and engine
housing to increase stroke.
• With spacers in place, follow
Steps 1-3 in this procedure.
• Remove spacers and torque
transmission mounting bolts.
• Continue process starting at
Step 4.
G
O
O
D
Hold
1
2
Let up on pedal. DO NOT
push pedal down again or
wear tab will return to the
wrong position.
3
Install and tighten 4
shipping bolts (7/16" x 14
x 1-3/4 UNC) until they
quit turning.
Note: This will remove the
gap between the sleeve
and the pin.
4
Remove
shipping bolts.
5
Push pedal down and
squeeze clutch brake
5 times to reposition
bearing.
6
5X
Before
After
No gap between
sleeve and pin
Gap
Shipping
Bolt
Sleeve
Pin
To Next Page
Loading...
