52
Hydraulic Linkage
Solo Advantage Lube Hose Assembly With Hydraulic Linkage
Installation Process
1. Install brass fitting into grease port on left side of
release bearing housing using Weatherhead socket.
Tighten hand tight and continue to turn until the
opening of the fitting is facing toward the 6 o’clock
position
2. Install lube hose into brass fitting and tighten until
hand tight, then turn an additional 2 turns.
3. Lubricate release bearing until grease purges from
release bearing housing. Use NLGI #2 or #3 Lithium
complex grease. Reference Eaton lubrication manual
TCMT0021 for specific instructions.
4. Install hand hole cover A-8173 with grommet biased
towards transmission in the clutch housing. Secure
the hand hold cover with two 5/16 x 18 x 1/2 inch
long bolts.
5. Insert plug into hole in upper left side of the clutch
housing where the horizontal lube hose is utilized.
Note: If the lube hose assembly should need servicing it can
be replaced without removal of transmission.
Parts Required:
1 - K-4050 Lube hose assembly kit
(includes brass fitting, lube hose, and plug)
2 - A-8173 Hand hold cover with grommet
To Next Page
Loading...
