53
Hydraulic Linkage
1. Fitting is assembled to hose hand tight. Attach the
brass fitting to the release bearing housing hand
tight and turn fitting until opening of fitting is at the 9
o’clock position when facing the engine. Install the
hose into fitting until hand tight and turn 1/6 turn.
Refer to diagram.
2. Transmission installation; remove the nuts from the
brass fitting with the grease zerk. Install the trans-
mission and insert the brass fitting through the hole
in the left side of the clutch housing. Reinstall the
brass nuts and tighten.
3. Lubricate release bearing until grease purges from
release bearing housing. Use NLGI #2 or #3 Lithium
complex grease. Reference Eaton lubrication manual
TCMT0021 for specific instructions.
4. Install 4305231 hand hole cover to protect the clutch
from contamination.
To Next Page
Loading...
