1
Put transmission in gear.
Be sure new clutch brake
has been installed.
3
Position transmission
so it is square to and
aligned with engine.
4
Mesh splines by moving transmission
forward and rotating the output shaft.
Do not use excessive force. Do not let
the transmission hang unsupported
in the discs.
5
Install mounting bolts and
torque to OEM specs.
Note: If you have a hydraulic
linkage,
2
Make sure that the yoke
fingers remain in the up
position until they are over
the release bearing housing.
CAUTION
IMPORTANT
Do not add lube to the input shaft
splines (Never seize or grease). The
discs must be free to slide.
Do not force transmission against clutch
with yoke fingers in the up position. This
will break the cast webbing of the clutch
causing damage that is not warrantable.
Do not use excessive force. If it doe
s not
enter freely, investigate the cause of
problem and make any necessary changes.
Do not let the transmission drop or hang
unsupported in the driven discs. This
can cause the discs to become distorted
and the clutch to not release.
WARNING
To Next Page
Loading...
