Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 94
Power Schedule
Define a Power Schedule
1. Access the Web interface and log in.
2. Under Power Management, select Outlets. The Outlets page displays.
3. Select an outlet and click the outlet name. The Outlet Settings dialog displays.
4. Check the Power Schedule checkbox.
5. Add an action in the first action block by selecting either On, Off, or Reboot from the drop-down list.
l
None: The actions in this schedule are not executed. This is the default upon opening this dialog. (You
can use this setting to hold the settings for future activation.)
l
Off: Select this value to switch off the current outlet according to the corresponding schedule you
specify.
l
On: Select this value to switch on the current outlet according to the corresponding schedule you
specify.
l
Reboot: Select this value to switch off and then switch back on the current outlet according to the
corresponding schedule setting. The delay between the Off and the On can be set on the Outlet
Settings dialog using the Power Reboot Period field (see Step 9 on page 92). With this setting,
additional actions scheduled by the Further Actions selections are disabled.
6. Set the time schedule for this action by selecting a time from the “at:” drop-down list.
7. Set the date schedule for this action by selecting a date from the “Date of Action” selection calendar.
8. Optional. You can add additional scheduled actions. For example, suppose your first action is On. You can
pair it with a subsequent Off action. The schedule for this second action is set by selecting Off from the
Further Action drop-down list and setting values in the date and time fields. By default, this second action
is set to "None," meaning nothing more will happen.
l
None: The actions in this schedule are not executed at the specified time. This is the default if the
Action is set to Off or On.
l
Off: Select this value to switch off the current outlet according to the corresponding schedule setting.
9. Set the schedule for this action by selecting a date and time from the drop lists for the “at:” and Date of
Action” field.
10. Click Save.
NOTE Power schedules can be set by an Administrator with Read/Write/Control only.
NOTE “Date of Action” fields are only available when the “Recurrent” checkbox is
unchecked. This field specifies the date when the action will be executed, but only
once. If your want the action to be scheduled to repeat, see Step 11.
NOTE This date and time must occur after the date and time set for the first action.
To Next Page
Loading...
