Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 129
Type Code 2 or 3 (ePDU or User)
Type 2 alarms and events are triggered from the ePDU. These alarms and events are primarily threshold
crossings when the operation measurement is beyond the threshold value range setting. Type 2 alarms and
events also provide the state of optional connected equipment.
Type 3 alarms and events are triggered from user actions.
1 02563 *Not used
1 02564 Wrong data type
1 02565 String too long
1 02566 *Not used
1 02567 *Not used
1 01025 *Not used
1 01026 Semantic error
1 01027 Impossible to open log file
1 01028 Impossible to write data in log file
1 01029 Impossible to seek data in log file
1 01030 Impossible to read data in log file
1 01031 Mutex not available
1 01032 *Not used
1 01033 Impossible to clear LOG file
1 03585 Initialization of SSH task failed
1 03076 Error writing in flash memory during an upload
1 03077 End signature of the uploaded file does not match
1 03078 Checksum of the uploaded file does not match
1 03586 Reading of the host key file (or table) failed
1 03587 Listening of SSH socket failed
1 03588 Acceptance of SSH socket failed
1 03589 Break received
1 03590 Max number of SSH connection reached
1 03591 Certificate error
1 03592 *Not used
1 04865 Error reading from the 12C Eeprom
1 04866 Error writing to the 12C Eeprom
1 03841 SNMP bad trap number
Table 10. OS or System Alarms and Events (Continued)
Type
Code Identification Code Alarm or Event
To Next Page
Loading...
