Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 111
Enable/Disable the Telnet Interface
1. Access the Web interface and log in.
2. Under Network and Security, select Global. The Security page displays.
3. In the Ports Settings panel, select Te l n e t from the Console drop-down list to enable the Telnet interface,
or select Disabled to disable it.
4. If enabled, the Telnet Port entry box is active. Type the port number.
5. Click Save.
6. Open the System submenu in the Settings menu. In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Enable/Disable the SSH Interface
1. Access the Web interface and log in.
2. Under Network and Security, select Global. The Security page displays.
3. In the Ports Settings panel, select SSH from the Console drop-down list to enable the SSH interface, or
select Disabled to disable it.
4. If enabled, the SSH Port entry box is active. Type the port number.
5. Click Save.
6. Open the System submenu in the Settings menu. In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Enable/Disable FTP
1. Access the Web interface and log in.
2. Under Network and Security, select Global. The Security page displays.
3. In the Ports Settings panel, check the FTP Enable check box to enable FTP, or uncheck the box to disable
it.
4. Click Save.
5. Open the System submenu in the Settings menu. In the Network Management Card panel, click Restart
network management card to restart the ePDU Network Management and Control (eNMC) module.
Set Authentication Mode
1. Access the Web interface and log in.
2. Under Network and Security, select Global. The Security page displays.
NOTE Selecting a console type on the Security page makes the corresponding port entry
box active.
Not selecting a console type makes the corresponding port entry box inactive and
grayed-out.
To Next Page
Loading...
