Eaton ePDU G3 - 7 Serial Interface Operation; Supported Commands

Eaton ePDU G3 Operation Manual P-164000277—Rev 5 68
Chapter 7 Serial Interface Operation
This section describes the command line interface (CLI) commands used to remotely configure and monitor
the Eaton Enclosure Power Distribution Unit (ePDU) G3 through the serial interface connection or network
connection between the and a laptop or workstation.
Access to a CLI is provided through a terminal emulation program, such as HyperTerminal, Telnet, or SSH. A
maximum of five concurrent sessions (Telnet or RS-232 port) are allowed.
Supported Commands
The ePDU CLI command set for managing and monitoring the ePDU includes the following commands:
l
?
l
info
l
quit
l
get
l
set
l
pdu
NOTE Observe the following:
l
Command variables are represented in command input syntax surrounded by
angle braces (< >).
l
Optional parameters are represented in command input syntax surrounded by
straight brackets ([ ]).
l
For data of type array, the 'x' character as index of array in command input syntax
means all indexes.
l
Commands are case sensitive, but object names are not case sensitive.
NOTE You must be logged into the ePDU before commands can be sent.