Eaton ePDU G3 - Type Code 0 or 1 (os or System)

Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 128
Type Code 0 or 1 (OS or System)
!
IMPORTANT
For Type Code 0 and Type Code 1, always contact customer support for assistance. These errors
are not user-correctable.
The Type Code 0 and Type Code 1 alarms and events are triggered from the OS or the system. Figure 96
provides an example of a Type Code 1 system alarm number code. It only contains an 5-digit identification code
(no index code).
Figure 96. Example Type 1 Code
Table 10 lists OS or System alarms and events.
Table 10. OS or System Alarms and Events
Type
Code Identification Code Alarm or Event
1 03073 Code unreachable
1 03074 Heap overflow
1 03075 Not enough memory in Heap
1 02817 A command is sent to an unavailable device CAN
1 02818 *Not used
1 02819 Impossible to open a session with a CAN device
1 02820 No answer from a CAN device
1 02821 *Not used
1 02822 The number of CAN devices discovered on CAN bus is too great
1 02823 Command unknown
1 02824 Device CAN Id out of range
1 02825 Time duration of a command is too long
1 02826 Report acquired from CAN device is wrong
1 02827 Report descriptor acquired from CAN device is wrong
1 01281 Mutex not available
1 01282 HID object Id out of range
1 01283 Report empty or not valid
1 01284 Report Id out of range
1 01285 Not enough memory in HEAP
1 01286 Duration of the acquisition of Teridian is too long
1 01282 HID object Id not in list of data saved in EEPROM
1 02561 *Not used
1 02562 *Not used
1
0
28
20
Alarm number code 102820: No answer from a CAN device
Identication Code = 02820
Type Code = 1 (System)