Network Communication Configuration
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 46
Verify Web Operation After Configuration
To verify the communications module is operational and that you can access the Web interface:
1. Open a Web browser.
2. Enter the IPv4 or IPv6 address in the address bar in the following format:
http://<IPv4 address> or http://<IPv6 address>
3. When the user authentication pop-up dialog displays, type admin in the User name field and admin in the
Password field.
4. The home page opens with the ePDUOverview page.
NOTE If you choose not to use the procedure to configure the communications module
without the DHCP server installed, you can connect to the ePDU using the default
address: http://192.168.123.123
To Next Page
Loading...
