Eaton ePDU G3 - Settings Configuration; User Access Accounts; Network and Security Settings; Access Privileges

Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 90
7. To reset the threshold values to the default values, click Default, then click Save.
8. To reset a kWh (kilowatt hour) counter to zero, click Reset kWh, then click Save.
9. To reset the maximum power counter to zero, click Reset Max Power, then click Save.
10. To cancel this action and return to the Overview page, click Cancel.
Groups
Review/Modify ePDU Groups
1. Access the Web interface and log in.
2. Under Power Management, select Groups. The Groups page displays.
3. Review basic monitoring information for Groups measurement settings.
4. For Users with Read/Write privileges. To apply an operative action to all outlets in a selected group,
select the corresponding checkbox and select one of the following values from the drop-down list adjacent
to the group, then click Save.
l
On: Turn on the selected group of outlets.
l
Off: Turn off the selected group of outlets.
l
Reboot: Reboot the selected group of outlets.
5. To modify ePDU threshold values for a specified group, click the link on the group friendly name. The
Group Settings dialog displays.
6. Administrator or User with Read/Write privileges only. To specify the duration outlets in this group will
be Off before switching On during a reboot, type the number of seconds the outlets should be Off in the
Power Reboot Period text box. Click Save.
NOTE If you do not save the action, the kWh counter remains unchanged.
NOTE In the toolbar, Turn On/Off Groups will only appear for Switched and Managed
ePDUs.
NOTE Click the red arrow next between the Current (%Load) and the voltage columns to
see additional Branch Circuit outlet information.
NOTE This setting overwrites the Power Reboot Period defined for individual outlets on the
Outlet Settings dialog.