Eaton ePDU G3 - Circuit Breakers

Introduction
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 5
Circuit Breakers
Circuit breakers activate if the load current rating of an outlet section exceeds 16A (Europe) / 20A (US). Power
to the outlet turns off automatically. To reset the circuit breaker, turn the breaker from Off to On.
Figure 4 shows circuit breaker examples.
Figure 4. Circuit Breakers
NOTE 1 The On/Off positions are indicated on the circuit breakers.
NOTE 2 To manually disconnect power to a device that is connected to the ePDU,
disconnect the device power cord from the ePDU outlet.
NOTE 3 To disconnect power on models without a circuit breaker, disconnect the ePDU
input power cord.