Eaton ePDU G3 - Logs Management; Trap Notification Configuration

Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 99
1. Access the Web interface and log in.
2. Under Settings, select Access Accounts. The Access Accounts page displays.
3. In the LCD Access panel, perform the following:
l
Activate the feature to change the password.
l
Type the LCD password.
l
Type the LCD password again.
4.Click Save.
Configure Local User Access
1. Access the Web interface and log in.
2. Under Settings, select Access Accounts. The Access Accounts page displays.
3. In the Multi-User Access panel, select Add a local user from the Add drop down list. The Users Settings
dialog displays.
4. Perform the following:
l
Type the user’s login user name to replace the default name.
l
Type the user’s password (minimum of five characters).
l
Type the user’s password again.
5. Choose one of the following profile characteristics:
l
Admin: This user has administrator privileges and controls the access of other users to the Web
interface. The Administrator can restart the communications module, but cannot perform a firmware
upgrade.
l
ePDU User: This user has access to the ePDU and either read only or restricted read-write privileges.
l
Outlet User: This user has access to the specified outlet or outlets. Select the outlet or outlets and the
user-defined groups this user can access.
6. Choose one of the following security levels:
l
No Access: The user is not allowed to access the Web interface.
l
Read-Only: The user can access the Web interface, view the measures, and view the thresholds of the
outlets and groups. This user is not allowed to change any settings or perform actions.
l
Read/Write: The user can access the Web interface, view the measures, and is allowed to change
settings.
7. To configure an e-mail address for this account, click the link of the e-mail address corresponding to this
user. See “Configure the E-mail Notification Settings” for more information.
NOTE 1 Only an administrator can create or modify a user account.
NOTE 2 Local users can use this user name and password for authentication if the
authentication mode selected in the Network Security Global submenu is Local (see
“Set Authentication Mode” on page 111).
NOTE 3 The User name is used for authentication. It must be unique. If there is a name
conflict when you are creating a new account, a warning message displays.