Maintenance and Alarms
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 123
8. In the Network Management Card panel, check Firmware upgrade enabled and click Browse to find the
upgrade file.
Figure 91. System Settings Page
9. From the Open window, select the Image<xxx>.bin file, and click Open.
10. In the Network Management Card panel, click Upgrade Network Management Card to launch the
upload. A progress bar shows the progress of the update.
Do not disturb the upgrade until the progress bar shows complete.
11. When finished, a message displays and the communications module restarts automatically. The upgrade
takes four to five minutes. When the upgrade completes, refresh the Web pages.
To Next Page
Loading...
