Operation Overview
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 41
Figure 36. Reset the eNMC Module from the Web Interface (Metered Input ePDU G3)
For a hardware restart, locate the Reset opening (labeled R) on the ePDU (see Figure 37). Insert a probe, press
the recessed button, and retract the probe. This method is not necessarily the best choice because the
communications module does not force the system to save the parameters in the file system before restarting.
The H/W restart button does not affect ePDU outlet status. The energy consumption is still recorded during the
reboot of the eNMC module.
NOTE When using a hardware restart to restart the eNMC module, there is no mandatory
check to ensure that the file system parameters are saved before restarting.
To Next Page
Loading...
