0 About this Manual
0.1 List of revisions
SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.com 5
0 About this Manual
This manual describes the installation, commissioning and programming of
the following SmartWire-DT gateway
• EU5C-SWD-EIP-MODTCP
The SmartWire-DT (SWD) communication system provides electromechani-
cal switchgear and pilot devices with communication capabilities.
More information on the topic SmartWire-DT can be found
• "SmartWire-DT The System", MN05006002Z
• "SmartWire-DT Modules IP20", MN05006001Z
• "SmartWire-DT Modules IP6x", MN120006
You can find further information on the topics SmartWire-DT and the Smart-
Wire-DT modules in the following documents:
• Instructional leaflet „EU5C-SWD…“, IL05006001Z
Download Center
The XSoft-CoDeSys software described in this manual, as well as the SWD-
Assist engineering tool, can be downloaded by visiting the
Eaton Download Center at:
http://www.eaton.eu/software
0.1 List of revisions
This is a fully revised version. and replaces version
09/11 of MN05013002Z. In contrast to previous versions, which described
SmartWire-DT gateways for various field buses, this version only covers one
single SmartWire-DT gateway. The following table show the most important
changes that have been made in terms of content:
￫
The aforementioned documents, as well as the manual you are
reading right now, can also be downloaded free of charge from
the Internet in PDF format at:
http://www.eaton.eu/doc
www.eaton.eu/DE/￫ Customer support ￫ Download Cen-
ter – Documentation
Enter the document number ("120003" for example) or "SWD"
into the Quick Search text field.
Publication date Page(s) Subject New Modi-
fied
01/13 91 „"Replacement during operation permis-
sible" device parameter“
j
12/16 5,6,73 Target group, Addressing modes for Modbus j
08/17 92, 102 Baud rates added j
To Next Page
Loading...
