SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP 08/17 MN120003Z EN www.eaton.com 1
Contents
0 About this Manual ..................................................................... 5
0.1 List of revisions ............................................................................ 5
0.2 Target group................................................................................. 6
0.3 Exclusion of liability ...................................................................... 6
0.4 Reading conventions.................................................................... 7
1 SmartWire-DT Gateway EU5C-SWD-EIP-MODTCP................. 9
1.1 Proper use.................................................................................... 9
1.2 Overview of functions.................................................................. 9
1.3 Versions ....................................................................................... 10
1.4 Important data for engineering..................................................... 11
1.4.1 Field bus connection .................................................................... 11
1.4.2 Baud rate...................................................................................... 12
2 Installation .................................................................................. 13
2.1 Setting the gateway's field bus address ...................................... 13
2.1.1 Default settings Ethernet address ............................................... 13
2.1.2 Obtaining an Ethernet address..................................................... 13
2.1.3 Resetting the Ethernet address ................................................... 17
2.2 Mounting Considerations ............................................................. 18
2.2.1 Mounting the EU5C-SWD-EIP-MODTCP gateway on a top-hat rail 18
2.2.2 Screwing the EU5C-SWD-EIP-MODTCP gateway into place....... 19
2.3 Potential Relationship between the Components........................ 19
2.4 Connecting the power supply ...................................................... 20
2.5 Connect SmartWire-DT ................................................................ 22
2.6 Connect field bus ......................................................................... 23
2.7 Connecting the diagnostics interface........................................... 24
2.8 Wiring in accordance with EMC requirements ............................ 25
3 Commissioning .......................................................................... 27
3.1 Putting the SmartWire-DT into operation..................................... 27
3.1.1 Reading of target configuration.................................................... 28
3.1.2 Switching on when the target configuration is stored ................. 29
3.1.3 Switching the gateway on when a planned SWD configuration is al-
ready stored .............................................................................29
3.2 Take the field bus into operation.................................................. 29
3.2.1 Creating EthernetIP/Modbus-TCP field bus communication........ 30
3.2.2 MS-LED status display ................................................................. 31
3.2.3 POW status display...................................................................... 31
To Next Page
Loading...
