Rear Section
54
12. Install the 5th/reverse synchronizer hub snap ring
on the countershaft.
13. Install the reverse speed synchronizer ring.
Note:
The reverse synchronizer ring IS coated
with EFM II and is smaller than the other
rings.
689
127
14. If necessary, replace the 5th/reverse shift yoke
nylon pads.
15. Install the 5th/reverse shift yoke in synchronizer
sleeve groove. Pull the yoke backwards until
engaging with the linked shift block.
EA099
136
16.
Install the two pivot pins of 5th/reverse shift yoke.
Note: Apply Eaton 677 sealant to pin threads.
Torque = 10-16 N.m (7-12 Lb.ft)
125
135
134
17. Install the reverse gear needle bearing on the
countershaft.
124
To Next Page
Loading...
