Rear Section
Rear Section
55
Note:
Use 1 (one) Eaton P/N 3348906 bearing.
18. Install the reverse gear on the countershaft.
19. Install the reverse idler gear needle bearing on
the idler shaft.
EA155
123
118
20. Install the reverse idler gear on the shaft with
the most protruding side of the hub facing the
housing outside.
704
21. Install the reverse gear with the rear ball
bearing together on the mainshaft with the most
protruding side of the hub facing the housing
inside.
22. Install the ball bearing thrust washer on the
countershaft.
Note:
The thrust washer has a retaining ball,
which should be installed with the washer.
114
702
701b
23. Install the countershaft rear ball bearing using
special tools E012001 and E012003.
088a
704
To Next Page
Loading...
