Eaton Powerware 9390 User Manual

Introduction
1-3
EATON Powerware
®
9390 UPS (100–160 kVA) Installation and Operation Manual S 164201554 Rev E powerware.com
1.2 Using This Manual
This manual d escribes how to install and operate the Powerware 9390 UPS (100–160 kVA)
cabinet. Read and understand the procedures described in this manual to ensure
trouble-free installation and o peration. In particular, be thoroughly familiar with the REPO
procedure (see page 10-7).
The information in this manual is divided into the sections and chapters listed. The system,
options, and accessories being installed dictate which parts of this manual should be read.
At a minimum, Chapters 1 through 3 and 8 through 10 should be examined.
쑺 Chapter 1, “Introduction” – provides a brief description of the UPS system, a
description of the content of each chapter, text conventions used in the manual, safety
warnings, and reference information.
Section I, Installation
쑺 Chapter 2, “UPS Installation Plan and Unpacking” – explains how to prepare the site
for the installation of the UPS system. It discusses equipment environmental
requirements, inspecting, and unpacking cabinets.
쑺 Chapter 3, “Installing the UPS System” – describes how to install and wire the UPS
cabinet and optional equipment.
쑺 Chapter 4, “Batteries” – provides battery safety and installation information.
쑺 Chapter 5, “Installing a Remote Emergency Power-off Control” – contains information
for installing the optional REPO control.
쑺 Chapter 6, “Installing Options and Acce ssories” – contains information for installing an
X-Slot Powerware Hot Sync CAN Bridge Card, parallel control wiring, an RMP II, a Relay
Interface Module II (RIM II), or a Supervisory Contact Module II (SCM II).
Section II, Operation
쑺 Chapter 7, “Understanding UPS Operation” – provides information on why and how a
UPS works.
쑺 Chapter8,“Features,Options,andAccessories”–describes the standard and optional
UPS features and available accessories.
쑺 Chapter 9, “Using the Control Panel” – describes the controls and indicators found on
the control panel and shows the various information screens displayed on the LCD.
쑺 Chapter 10, “UPS Operating Instructions” – contains startup and shutdown procedures
for the UPS system.
쑺 Chapter 11, “Using Features and Options” – contains descriptions and instructions for
the UPS system features and options.
쑺 Chapter 12, “Responding to System Events” – listsallthealarmsandnoticesthatoccur
during operation of the UPS system.
쑺 Chapter 13, “Communication” – describes the communication features of the UPS
system.

Eaton Powerware 9390 Specifications