Eaton SC200 - Communications Security; Serial Communications (Usb;Rs232;Ethernet) Security

Communications
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
95
DCTools or PowerManagerII Setup
 Use similar settings for other software.
1 Install DCTools/PowerManagerII on the PC/laptop.
2 Double-click the DCTools/PowerManagerII icon to open the connection manager.
3 Go to Connection > New to open a new connection dialog box.
4 Enter:
Connection Name:
<as required>
Comms Enabled:
True
Protocol:
S3P
Connect Using:
Local Network
S3P Address:
0 (0 = Broadcast, 1-65279 = individual address)
Server IP Address:
The IP Address of the SC200. Allocated by network
administrator.
Server Port:
15000
Telnet
Cleared
5 Press OK. DCTools/PowerManagerII will now connect to the device connected to the
SC200's RS232 port.
Communications Security

SC200 settings cannot be changed if:
All communications are disabled (see S3P Access on page 95 and HTTP/HTTPS
Access on page 96), and
Keypad access (see details on page 10) is Read Only, or PIN Protected and the
keypad access PIN is lost.
In this situation the SC200 will continue to function, but no configuration changes can
be made. Contact your Eaton dc product supplier or Eaton for advice (see Worldwide
Support on page 125).
Serial Communications (USB/RS232/Ethernet) Security
S3P Access
S3P is the serial communications protocol used by the SC200 to communicate with DCTools or
PowerManagerII via the USB, RS232 or Ethernet port.
 S3P Protocol is not used by the web server.
► To Enable/Disable S3P access
On the SC200 keypad go to Settings > Setup > S3P. Select Enabled or Disabled.
Or:
1 Connect to the SC200 with a web browser (see details on page 82).
2 Go to Configuration > Communications > Remote Access Protocols > S3P.
3 Set Access to Enabled or Disabled.