Eaton SC200 - Serial (RS232) Communications

Communications
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
89
Diagnostics
The following diagnostic information is available.
Parameter
Description
Where to find:
Bus Message Count
Number of messages. Does not include messages
with bad CRC.
DCTools/Web:
Communications > Modbus
> Diagnostics
Bus
Communication
Error Count
Number of CRC errors.
Slave Exception
Error Count
Number of exception errors.
Slave Message
Count
Number of messages to the SC200.
Slave No Response
Count
Number of messages received for which no
response was sent.
Bus Character
Overrun Count
Number of messages received with more than
256 characters.
 All counts are since the last SC200 restart or since counter was reset.
Serial (RS232) Communications
The parameters of the RS232 serial port can be configured, if required for a specific RS232
device. However, for most applications use the default settings.
Parameter
Description
Where to find:
Baud Rate
Default: 19200
SC200: Settings > Serial Port
Settings
DCTools/Web:
Configuration >
Communications > Serial >
Port Settings
Parity
Default: None
Stop Bits
Default: One