Eaton SC200 - Rectifiers

SC200 Handbook
32
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
Rectifiers
The SC200 registers all rectifier modules as they are inserted into the dc power system.
Information
The following information is available about rectifiers.
Parameter
Description
Where to find:
State
Registered - communicating with the SC200.
Un-registered - there is a rectifier compatibility or
communications problem.
SC200: Rectifiers > Enter
(Use Left and Right keys to
scroll to other rectifiers)
DCTools/Web: Rectifiers
Serial Number
(S/N)
Rectifier serial number.
Load Based Run
Time
The time the rectifier has been operating since it was
registered.
AC Voltage
The ac voltage measured by the rectifier (single-phase
rectifiers only).
Phase Voltages
The ac phase voltages measured by the rectifier (three-
phase rectifiers only).
Voltage
Rectifier's dc output voltage.
Current
Rectifier's output current.
Heatsink Temp
The measured rectifier heatsink temperature.
Max Power (Limit)
Rectifier's maximum output power (factory set).
Power
Rectifier output power as a percentage of Max. Power
Limit.
DCTools/Web: Rectifiers
Max Current Limit
The maximum current limit value of the rectifier.
 Adjust Rectifier Current Limit to set a lower
operating current limit.
Min OVSD Set
Point
The minimum Over Voltage Shut Down set point that
the rectifier accepts.
Max OVSD Set
Point
The maximum Over Voltage Shut Down set point that
the rectifier accepts.
Status
Information about rectifier alarms.
Type
Rectifier manufacturer's model number.
SC200: Rectifiers > Enter
(Use Left and Right keys to
scroll to other rectifiers)
Software Version
Version of rectifier embedded software.