SC200 Operation
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
► To select a new language for the SC200 display
Either:
On the SC200 keypad go to: Settings > Language > Edit.
Select the required language and press Save.
Or:
In DCTools/Web go to Communications > Front Panel.
Type the two letter language code in the Language Code field.
This code is the "xx" in the file name of the Translation File (SC200-xx-Vyyy.icp). For
example: zh = Chinese. Clear the Language Code field (blank entry) to revert to English.
Click Apply Changes. The display language will change.
The message "Waiting for database to become available for update ..." may display for a few
seconds.
If an incorrect or unavailable language code is used the display language will remain/revert to
English.
SC200 Firmware Upgrade
If required, the embedded software (firmware) in the SC200 can be upgraded from a PC/laptop
via a web browser.
► To use a web browser for a Firmware Upgrade
1 Connect to the SC200 via a web browser. (For details see Ethernet Communications on
page 82.)
2 Check the SC200 internal clock shows the correct time. If necessary set the correct time. See
SC200 Internal Clock on page 14.
3 Go to Tools.
4 Select Firmware Upgrade: Launch.
5 Select the file (*.icp). Click Next, then click Proceed.
Some configuration settings may be lost when the firmware in the SC200 is
upgraded. Refer to the new firmware Product Release Notes for details of
specific configuration settings that are affected. Check the configuration
after upgrading. Backup any changes to the configuration.
It is likely that configuration settings will be lost if the firmware in the
SC200 is downgraded. If a firmware downgrade is required, trial the
downgrade and check the configuration before implementing it at a site.
To Next Page
Loading...
