Eaton SC200 - Display Settings; Main Screen Parameters

SC200 Operation
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
11
Display Settings
► To change the display contrast
Use the keypad to go to: Settings > Setup > Contrast > Edit.
► To change the display language
See Language Options on page 16.
► To change the display orientation (horizontal/vertical)
Either:
Use the keypad to go to: Settings > Setup > Orientation > Edit.
Select the required orientation (vertical, horizontal-left or horizontal-right). Press Save.
Or:
In DCTools/Web go to: Configuration > Communications > Front Panel.
Select the required orientation (vertical, horizontal-left or horizontal-right). Click Apply.
 The functions of the navigations keys also change to suit the new display orientation.
Main Screen Parameters
The parameters displayed on the SC200 main screen are configurable. Either two large or three
small parameters can be displayed. The default settings are two large parameters with the
values Bus Voltage and Rectifier Current.

Value 1

Value 2
► To change the parameters displayed on the main screen
Either:
Use the keypad to go to: Settings > Setup (tab) > Display Settings > Main Screen Layout.
Or:
In DCTools/Web go to: Configuration > Communications > Front Panel.
Set Main Screen Layout to Two Large or Three Small.
Select the required parameters (see Note 1) for Value 1 and Value 2 (and Value 3 if Three
Small is selected).
For each of Value 1/2/3 Units, select No Units, e.g. Battery Temp. 25, With Value, e.g.
Battery Temp. 25°C, or With Label, e.g. Battery Temp. (°C) 25.
If Analog Input is selected as a display parameter, then also select a value for Value 1/2/3
Index. See Note 2.