Eaton SC200 - Communications Options; Direct (USB) Communications; Ethernet Communications

SC200 Handbook
82
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
Communications Options
The SC200 system controller has a standard USB interface, a standard RS232 serial interface
(XS1) and an Ethernet 10BaseT interface (XS31) for communication with a local or remote PC or
laptop, or a Network Management System (NMS). See the diagrams on page 2 for locations of
these connectors.
The standard communications options for an SC200 system controller are described in the
following sections. For other communications options contact your Eaton dc product supplier
or see Worldwide Support on page 125.
Direct (USB) Communications
See SC200 Operation Using a PC/Laptop on page 13.
Ethernet Communications
Connections

SC200 system controller

PC/laptop with:
PowerManagerII and/or DCTools (see details on page 83), and/or
Web browser (see details on page 84), and/or
Network Management System using SNMP (see details on page 85), and/or
Building management System using Modbus-TCP (see details on page 88).

Communications network. Protocol: TCP/IP
MAC Address
► To view the MAC Address of the SC200
Either:
Use the SC200 keypad to go to: Info
Or:
In DCTools/Web go to: Configuration > Communications > Ethernet
 The Media Access Control (MAC) address is the SC200’s unique Ethernet address assigned by the
manufacturer.