Eaton SC200 - Page 105

Communications
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
97
► To change access to the web server
Set the following parameters as required.
Parameter
Description
Where to find:
HTTP Access
Enable to allow un-encrypted access to the SC200
web server.
Disable to prevent un-encrypted access to the
SC200 web server.
SC200: Settings > Setup
DCTools/Web:
Communications > HTTP
(Web)
HTTPS Access
Enable to allow encrypted access to the SC200
web server.
 HTTPS access will be slower than HTTP
because of the encryption process.
Disable to prevent encrypted access to the SC200
web server.
User Setup
► To setup specific users and control their access levels
For each user, set the following parameters as required.
 If there are no active users then web access is disabled. Use DCTools to set up an active user.
Parameter
Description
Where to find:
User Name
This is not used in the login process (except for
"Default User"). It is displayed at the top-right of
the Web view screen.
DCTools/Web:
Communications > HTTP
(Web)
Logon ID*
The logon name of the user.
Password*
The password of the user.
 Lost passwords cannot be recovered. If a
password is lost then set a new password.
Read
Allows the user to view configuration settings
only.
Write
Allows the user to change configuration settings.
Backup
Allows the user to download configuration or
snapshot files.
Restore
Allows the user to upload configuration or
snapshot files.
Execute
Commands
Allows the user to stop and start control
processes.
Upgrade Firmware
Allows the user to upgrade firmware.
Edit User List
Allows the user to edit the user list and change
user access settings.
 *Leave both fields blank to allow Default User (anonymous) log on.