Eaton SC200 - Page 76

SC200 Handbook
68
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
Parameter
Description
Where to find:
Control Relay
The relay used to control the generator startup
and shutdown. If this is set to None, the
generator control process is disabled.
SC200: Control Processes >
Generator Control > Settings
(tab)
DCTools/Web: Control
Processes > Generator
Control
Can run with
mains present
Indicates whether the wiring between the
controller and the generator allows the controller
to start the generator even when the ac supply
has not failed.
Automatic control
mode
This determines which control functions, if any,
will cause the controller to automatically start
the generator when necessary. In addition to
these, smart alarms may be used to activate the
generator control output when necessary. See
Smart Alarms on page 49.
Battery capacity
The rated 10 hour (C10) capacity of the installed
battery strings. Should already have been set in
SC200: Battery > Battery or DCTools/Web:
Batteries.
Manual generator
run time
The maximum time the generator is permitted to
run following a manual start.
Generator Fail
Alarm Recognition
Period
A Generator Fail alarm is activated after this time
if the Generator Control output is active but the
ac supply has not been restored.