Eaton XV300 Series - Peripheral Interfaces

1. Description
1.5 Interfaces to peripheral devices
1.5 Interfaces to peripheral devices
The interfaces featured by your XV300 will depend on the XV version selected and can-
not be modified.
The nameplate will indicate which specific interfaces are included with the unit.
Figure 9: Interfaces
Interfaces on all HMI panels
 interface type
SD card slot
SDSCorSDHCconformingtotheSDA2.0spe-
cification
USB Host USB 2.0, not galvanically isolated, plug type A, Full
power (500 mA)
USB device USB 2.0, not galvanically isolated, plug type B
Ethernet 1 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100
Mbps
COM1 RS-232, not galvanically isolated, SUB-D plug 9-pole,
UNC nuts for interlocking
COM2 RS-485, not galvanically isolated, SUB-D plug 9-pole,
UNC nuts for interlocking
CAN CAN1, not galvanically isolated, SUB-D plug 9-pole, UNC
nuts for interlocking
Optional interfaces
Ethernet 2 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100
Mbps
Profibus Profibus DP, not galvanically isolated, SUB-D socket
9-pole, UNC nuts for interlocking
SmartWire-DT
®
4-pin WAGO connector (article no. 734-104) and 8-
pole ribbon cable plug
20
XV30012/15 MN048017 ENwww.eaton.eu