Eaton XV300 Series - SD Card

5. External connections
5.2 SD card
5.2 SD card
The slot for the SD card is on the side of the XV300 unit.
CAUTION
DATALOSS
IftheSDcardisbeingwrittentoandavoltagedropoccursorthecardis
removed,datamaybelostortheSDcardmayberuined.
Insert the SD card only when the XV300 is de-energized.
AvoidwritingtoSDcards.Reasons:
l SD cards have a limited number of write cycles.
l If there is a voltage drop while a write operation is in progress, data loss is highly
likely to occur.
Remove the SD card only when the XV300 is de-energized.
Before switching off the device, make sure that there are no programs writing
to the SD card.
Inserting the SD card
SD cards cannot be inserted the wrong way around.
Do not use force when inserting the card.
Push the SD card into the SD card slot until you feel it lock into place.
Removing the SD card
Push the SD card into the SD card slot all the way to the stop.
Pull the SD card out of the SD card slot.
Store the SD card in its case in order to protect it.
XV30012/15 MN048017 ENwww.eaton.eu
49