Eaton XV300 Series - List of Tables

List of tables
Table 1: Format conventions used throughout
this manual 12
Table 2: Enclosure versions for front mounting 18
Table 3: Enclosure versions for rear (panel)
mounting 18
Table 4: Front mounting versions with a 7.0" dis-
play 21
Table 5: Versions: flush mounting 10.1" display 21
Table 6: Rear (panel) mounting versions with a
7.0" display 21
Table 7: Rear (panel) mounting versions with a
10.1" display 21
Table 8: Std. pack 35
Table 9: Functional earthing specifications 43
Table 10: Configuration Plug connector MSTB
2.5/3-ST-5.08 44
Table 11: Specifications for connection to 24
VDC supply voltage 44
Table 12: Pin assignment COM1 RS-232, not gal-
vanically isolated, SUB-D plug 9-pole, UNC nuts
for interlocking 52
Table 13: RS-232 cable length based on baud
rate 52
Table 14: Pin assignment COM2 RS-485, not gal-
vanically isolated, SUB-D plug 9-pole, UNC nuts
for interlocking 53
Table 15: Specifications for RS-485 wiring 53
Table 16: PIN assignment for CAN interface as
specified in CiA) CAN1, not galvanically isol-
ated, SUB-D plug 9-pole, UNC nuts for inter-
locking 55
Table 17: Specifications for CAN wiring 55
Table 18: Pin assignment for Profibus DP, not
galvanically isolated, SUB-D socket 9-pole,
UNC nuts for interlocking PROFIBUS interface 57
Table 19: Specifications for Profibus wiring 57
Table 20: Pin assignment WAGO plug connector60
Table 21: Wiring the plug connector 61
Table 22: Overcurrent and short-circuit pro-
tective device standards 61
Table 23: Pin assignment for SmartWire-DT rib-
bon cable interface (pin header, 8-pin) 61
Table 26: Materials used XV300 68
Table 33: Overcurrent and short-circuit pro-
tective device standards 86
XV30012/15 MN048017 ENwww.eaton.eu
92